FP2 reboots in certain wifi networks

Airport problem long original topic.

Could be, but not easy to investigate.

Also using 2,4GHz or 5GHz band can cause such troubles. Hence my advice to possibly disable wifi and only use mobile data.

@yvonnee

Usual Wifi is using the 2,4GHz frequency band (same as bluetooth btw.) while
5G ->5GHz frequency band is becoming more common. It is a bit quicker and younger but not yet so common hence not as crowded as the basic 2,4GHz band.
Also there were interferences in very rare cases (I had one too) where the bluetooth signal interfered with the 2,4GHz wifi signal. So disabling BT is another hint btw. just to see.

Good if you router offers 5GHz, interferences (also with neighbors) should be less and performance better if your signal reception is good.

Afaik network problems generally should not cause reboots. Devices should operate reliable whether they have network access or not. Even if updates are downloaded the installation process just starts after the entire data was successfully received. The download just takes longer when signal reception is weak or interrupted. But there are users who experience more reboots when using a specific wifi connection. To find the cause is not an easy task as no clear relation between both of these can be identified.

Usually wifi is established by registering a specific device by a default name which most often is the individual devices mac address (should only exist once in the world fixed in silicone…). The router should reveal its network name (on the first registration, for reconnect it possibly may be hidden). You may go through all steps manually like scanning and accepting the new device via mac address. Now also go through the registration process on your device by selecting your wifi network and entering your networks security key. If all was done properly the registration process should finish and the connection establish.

There are more automated ways though like using the wps feature/hardware button on your router if available. Within a specific time slot the router scans for new devices taking over new network specific data. You would then only have to recheck and accept to take over and enable the connection. Also scanning a QR code offered within your routers configuration masc helps you to easily share registration setup data with new devices (if supported of course).
It´s not very detailed, but a rough overview. With a bit of practice that´s no problem for anyone to do it.
There may be an antenna for the wifi reception, but in case if it’s somehow damaged reception should be very poor or not available at all.