Unfortunately, I don’t have my own 3D printer, but I have come across various “3D printing service” sites on the Internet. I have now selected the following case via Printables: FP6 Case Unfortunately, I have absolutely no idea about the technology, so I opted for the material TPU. It is very im…

In my opinion the geometry of the case is so thin that it only makes sense to print with with 100% material as infill. That’s what I did some years ago, when I printed a case for my mobile phone. Especially if you’re planning to print it with TPU, which is a soft, rubber-like thermoplast. My recomm…

Ok, I am back from printing. The case printed very well and fits perfectly (in fact, I did not manage to get my phone fully in without applying a lot of force, but PLA is very hard). With TPU, it most probably will work, and all the holes seem to fit. I would give it a go for printing.

Would be great to see some pictures of the printed case with and without the phone in it.

I commissioned this case as a TPU print. It should arrive this week, then I can upload a photo as well.

Please find below two pictures of the printed file. As mentioned, I could not fit my FP6 in there, as PLA is too hard and does not flex. However, it will most probably work with TPU. [IMG_20250721_174554629] [IMG_20250721_174540188]

Thanks for showing your result! Maybe you can rework the undercut rib by grinding material away so your phone could slip into the case?! [image] mike_1312: The frame has an circumferential undercut of 1,1 mm to keep the phone in place. [image] If the complete inner dimensions are too narr…

I have printed the case in question on my Voron with Extrudr extra hard TPU with honeycomb grid. I used an earlier version which didn’t yet have the cutout for the power button and the usb c port position was a bit off but the current design fixed these issues (and I fixed them with a small knife, …

So, the case is here now and does its job quite well. The only issue is that it has a little too much play on the side where the power button is, and you can press it in there. It is made of TPU 95A with an infill value of 100. I would possibly choose a slightly harder material, then it would def…

Thank you for sharing feedback and pictures! Looks really nice. So the reccommendation with a 100% infill with TPU was OK for you?

Yes, definitely. If you are considering TPU as a material, I would always use 100 as the infill..

FP6 case - 3D printing

Discuss The Products

yvmuell August 7, 2025, 11:58am 30

Please not here in this topic as its off-topic.

Rather use this topic directly