Snowva
October 21, 2016, 1:59pm
1
Hello,
I have been trying to update my FP2 and everytime it initiates download, then when the bar reaches the end of the download, it gives me a “wait a moment” message which does not disappear. It rebooted itself once and afterwards it still said that I have the 1.0.
How can I solve this?
Thank you
See here:
Avoid that your phones enter standby mode during the update. You can do so by:
Taping on the screen from time to time
or
Set the “sleeping” time to the maximum (30 minutes) in Settings --> Display --> Sleep
or
Settings --> Developer options --> enable “Stay awake” (phone must be connected to charger)
For other tips and options, see here:
This is a troubleshooting guide for updating the FP2. For the FP1(U) check this guide .
Even though the updates are tested before they’re released, sometimes they don’t install smoothly on some of the phones. If you’re unlucky enough to experience issues, then there’s quite some information on how to get going again; both official information on the Fairphone Support pages and unofficial tips and tricks by other users on the forum. This wiki aims to provide an overview. If …
Snowva
October 21, 2016, 3:33pm
3
Thank you! I thought I had checked for similar topics but apparently missed that.
Will try those tips.
Best,
Snowva
Lidwien
Closed
October 24, 2016, 3:33pm
4
This topic was automatically closed 3 days after the last reply. New replies are no longer allowed.