Bottom module needed

[anon9989719]

I was comparing to this image, which shows no copper. I thought I read that the plastic can be removed and there are contacts underneath ??

This image is an extraction of the one on the following post and looks almost identical even to the metal contscts viewed through the holes

FP2 Bottom Module: Repair broken µUSB port and or mic

Hey, just desoldered my microphone from the bottom module. the (very thin) pcb is glued into the plastic case of the module. But with a heatgun the glue softened and you can pull it out. After that I put my heatgun on 380°C and desoldered the mic. I coverd the surrounding parts with kapton tape. But I ripped one half of one solderpad off the pcd(see picture, top right pad). The trace from that pad seemed to be connected to a via next to it. [image] That was written on my mic: S1263 277…